Week 14:Engineer's Day

Objective: To present on our final year project and demonstrate the prototype.



Activity:
-Accessed by Sir.Ahmad Basri and Sir Suhaimi.
-Time taken for the presentation and demo's is about 20 minutes.
-There's some recommendation from accessor in way to improve better the project if there any extra budget.


Conclusion:
-The presentation end with well condition.

Week 13:Poster

Objective:To finalize the project into a poster.

Drafted Poster

Finalize Poster

Week 12:Final Briefing for FYP2

Objective:To know on details about Technical report format and on the day tentative for Engineers Day.

Content:
-The FYP2 committee explained on how to refer for technical report and the due date for submitting the Report.
-Discussion on how to claim on FYP2 project.
-Discussion on how to present in-front of accessor.

Conclusion:
-All the FYP2 student must refer to FYP bmi link for any inquiries.

Week 11:FigureTroubleshoot circuitry

             At this week, im facing of a bit of problem on Proximity Sensor Circuitry which the sensor does not function effectively as i wish.After a day and refer the circuit to my supervisor it maybe cause of degree of sensing range must be altered.

Figure 5:Proximity sensor Circuit

This work take 2 weeks(week 12-13) to settle/alter up....

Week 10:Testing Prototype to get an end product

Objective:To analyse the final output of product.

After a few month through to build the mechanical prototype and ready with circuitry i had tested for twice to shred the raw plastic bottle with specific sizes.

Figure8:End product

Week 9:Voltage Regulator

Objective:To Study on how to regulate down the Voltage in to the PIC.

The LM7805 takes in a voltage between 7 and 30 volts and regulates it down to exactly 5 volts. The first capacitor takes out any ripple coming from the transformer so that the LM7805 is receiving a smooth input voltage, and the second capacitor acts as a load balancer to ensure consistent output from the LM7805.

Figure7:LM7805 circuit diagram

Week8:Method of Installation PIC board

Objective:To on installation of PIC Cicuit .

Step1-Insert an IC socket and 2 unit 1k ohm resistor

Step2-Insert 20Mhz oscillator and 2 unit 18pf capacitor

 

Step3-Insert the LED

Step4-Insert 2 unit 0.1uf capacitor

 

Step5-Insert 7805 voltage regulator

Step 6-Insert the pin header for 12V and 5 Volt (12V 0V 5V 0V)